Problem: The problems we had to faced were making a parallel circuit and a series circuit circuit into one and solder the circuits. We had to use a power source, lights, wires, and resistors. This is our first project where we had to solder a circuit, but if you already know what you are doing, this project should not be hard at all.
Solution: What I usedis one LED light, wires, 9 volt battery, three 180 ohms resistors, solder machine. The solutions for the problems that we had to face during this project was just to research for "How to make a Series Parallel circuit " and if you don`t know how to solder just research " How to solder" and that`s pretty much it. The only problem I had is that the wire that I was using was too thick so sometimes the wires would not solder together with the resistors or the LEDs so I had to twist the wires with the resistors so they could solder together.
Feedback: I liked this project because since I already know how to solder, so it wasn`t much of a challenge for me, but the only think I hate about soldering is that when you melt the LED into the wires some smoke comes out and that if that smoke gets on your eyes it burna, but other than that i really liked this project.